When you own a home, it comes with many responsibilities, both inside and outside. Homeowners have a hard time managing the energy and time to stay ahead of it all. In addition, if you have had a system of Sprinkler System Installations in Austin, it is yet another major responsibility.
Since the sprinkler system is responsible for simplifying soil moisture and watering management, most homeowners have them installed in their yard; however, the moment something breaks, the automatic watering loses its capacity rendering the homeowners stuck with a frustrating irrigation system. Therefore, reliable Austin Sprinklers installation is extremely important.
One of the most common inconveniences caused by the sprinkler system is skipping zones. Basically, an automated irrigation system is organized into different zones, each lu covering a part of the yard. Though these zones are part of the same sprinkler system, their operations are not dependent on others. If you are wondering what is the reason for a sprinkler system escaping a zone, here are some of the reasons:
Leaks
The easiest place to start while running a diagnosis of a skipped zone is to check the leaks. A break or loose connection in the supply line will block the water reaching the heads. When the water line in a particular zone leaks, it will impact the pressure needed for the zone to function.
Finding a leak can be sometimes easy and sometimes not. If you visually inspect the system when it is running, it often indicates a leak. Some other indicators of the leaks are dead spots, over soggy areas, and water pooling in an area. When you find a line leak easily, fixing it won't take much time. However, if you don't find the leak easily, it will take more effort.
Controller issues
If you cannot identify the leak by visual inspection, the next place you should be looking for is the controller. A wiring issue or malfunction in the controller can be the reason for the skipped zone. Actually, the irrigation controller is the system's brain. It acts like a small computer responsible for managing watering schedules and sending low voltage electric signals for opening the valves.
Usually, the repairer uses an electrical meter to test the controllers' voltage and ohms directly at the source. A wiring issue can be a likely problem if levels are outside of the normal range or not present at all. There can be other potential issues with a controller. Thorough testing can reveal it.
Valve issues
A number of problems can be associated with the zone valves that can impact the water supply. As soon as the electrical signal is sent from the controller to the valve of a zone, a properly functioning valve will open, thereby allowing the pressurized water to charge those zones lines. When the proper charge of the zone is reached, the heads get activated, and each zone gets irrigation.
When any of the processes within the valve get subjected to malfunctioning, the water supply required for the zone for functioning will be highly affected. Usually, repairers run several tests at the valve to figure out the skipped zone is caused by the valve or not
Pump Problems
For any irrigation system that uses natural water supply as its source, a pump is a must-have for pressurizing the water to run properly. When it comes to pump-driven systems, it can range from a simple crack in the line to a cumbersome pressure imbalance. If your pump is inside a well, you should immediately get in touch with a pump specialist prior to any irrigation service.
These are some of the reasons why your Austin Sprinklers installation is skipping zones.
Conclusion-
There are enough and more reasons why your sprinkler system might be skipping a zone. In any case, we understand that sprinkler issues can be frustrating, and the reasons behind them are far less important than "how quick can you fix it?". Maintaining your yard and the soil moisture around your home is paramount for any homeownership. We hope this blog helps you with your sprinkler systems.
Comments